Shower heads are very practical. They can transform a simple water stream into the most relaxing and delightful experience you can imagine. By varying the perforation pattern, you can get different results, from a light rain to a powerful hydrojet.
However, the greatest con of some shower heads is their inability to focus the water stream on certain areas of your body. For example, when you want to do a deep cleaning of your hair, but you can’t do it because the shower head is too high.
However, there’s a simple way to lower a shower head that won’t take you more than 5 minutes. You just need the necessary tools and materials to do it. In this article you’ll learn the complete procedure.
Importance of Lower Shower Heads
Sometimes, having a static shower head can be a disadvantage. For example, when you want to focus the water stream on certain points of stress accumulation in your body for relaxing effects. Or when you want to deeply wash your hair like in a beauty salon.
Lowering a shower head could also help you while cleaning your bathrooms, to focus water pressure on hard to reach areas and stubborn stains.
So, the possibilities are unlimited when it comes to lowering shower heads. However, there are some modifications you can make in your static shower head to change its position at your convenience. Below, you’ll find a step-by-step guide to learn how to do it.
Step by Step Guide to Lower a Shower Head
As said before, lowering a shower head can be useful in many cases. If you have a static shower head and you have no idea of how to change its position, don’t worry. Here’s a detailed explanation to learn how to do it.
Using a hand held shower head with a slide bar
Some hand held shower heads include a 24-inch stainless steel slide bar. This bar adjusts the height of the shower head to convenience, using an adjusting device that comes with the product.
The installation procedure is very simple and you just have to follow these simple steps:
- Place the slide bar vertically on the wall. Make sure the bar is 52 inches above the ground level.
- Using a pencil, make two marks on the wall indicating the final position of both ends of the slide bar.
- Drill the wall at the points marked using a drill and a 3/16-inch masonry drill tip. If the wall surface is covered with acrylic, fiberglass or other sturdy material, use a twist-drill bit.
- Then, use a ½-inch drill bit to increase the diameter of the holes.
- After that, insert a hollow-wall anchor in each hole. Use a rubber hammer to set them in place.
- Put the slide bar on the wall, so the holes on the mounting brackets match with the holes on the wall.
- Finally, install the slide bar using stainless steel screws.
Installing the Shower Head
Hand held shower heads come attached to a flexible steel hose for easy handle. Installing this type of shower heads is very simple. This is what you should do:
- Wrap the old shower head’s nut with a dry cloth.
- Grab the wrapped nut with a channellock and then turn counterclockwise.
- Remove the old shower head.
- Clean the thread of the shower arm and apply Teflon tape clockwise. This way, the Teflon tape won’t break while tightening the steel hose.
- Attach the flexible steel hose to the shower arm, turning clockwise.
- Turn on the shower to check for leaks. In case of leaks, repeat steps 4 and 5.
- Finally, install the adjustment device on the slide bar to adjust the height of the shower head.
Certainly, lowering a shower head is no longer a problem thanks to hand held shower heads with slide bars. As you can see, the installation process is very easy and you don’t need too many tools during the process.
Adjusting the height of a shower head is very convenient in homes where each family member has a different height. Certainly, taking a shower with a too low or too high shower head can be uncomfortable sometimes.
Best of all, hand held shower heads with slide bars prevent you from demolishing your shower walls, which can generate some extra costs that escape from your budget.